MakeZine ran an article on my 2017 Laser Science Project

493 0

On June 9, 2017, My article on everything that went right, wrong, and totally sideways on my laser cutting experiment for the Simon Baruch “Science Fair” was in the official blog/magazine of Make and the Maker Faire, “MakeZine!”

Click here for more.

Thank you AGAIN to everyone who re-posted, tweeted, re-tweeted, faced, booked, tubed, and everything else too!

A special thanks to the editors at Makezine that made my article look readable by humans.

Facebooktwittergoogle_plusredditpinterestlinkedinmail

Related Post

while loop

Posted by - October 18, 2015 0
[crayon-5ae11b84a20d9299145257/] Keep Reading : Pi Camera Resolution Fix Hello World LED Blinking Wire camera to pi

Phase One

Posted by - August 15, 2015 2
“Phase One” is where we learned basic raspberry pi use. we started with the unboxing of our model 2 B raspberry…

GPS AT Commands

Posted by - October 18, 2015 0
AT+CGPSPWR? if off : AT+CGPSPWR=1 Get status : AT+CGPSSTATUS? Get GPS : AT+CGPSINF RESET CODES : What mode ? –…

Leave a comment

Your email address will not be published. Required fields are marked *