SMS on PI

Posted by - November 22, 2015

SMS on your Raspberry Pi… Adapted from :  http://www.smssolutions.net/tutorials/gsm/receivesmsat/ This assumes you have set up your sim card, wired your modem correctly to your Pi, and are using a terminal program such as minicom. You may need...
Read More

Keep Reading : Send MMS From Serial Port on Raspberry Pi Serial Communication with SMS Modem (FONA) python to send a SMS message GPS RESPONSE CODE ORDER
Read More

Updated GPS & Battery commands for Sim808 / FONA Shield. Also works for LoNet Sim808

Posted by - October 23, 2015

Enable Charging Function  It is recommended to execute this process when first time to use the module. In the Serial Monitor columns of following tables, input of AT commands are in back, module returns values are in orange. Serial...
Read More

Keep Reading : Send MMS From Serial Port on Raspberry Pi Serial Communication with SMS Modem (FONA) GPS RESPONSE CODE ORDER SMS on PI
Read More

GPS RESPONSE CODE ORDER

Posted by - October 18, 2015

in response to AT+CGPSINF=0 0 longitude 1 latitude 2 altitude 3 UTC Broadcast Time 4 TTFF Time To First Fix 5 num Number of satellites 6 speed Speed Over Ground 8 course Heading Over Ground (degrees of compass where 0 = N) ...
Read More

Keep Reading : Serial Communication with SMS Modem (FONA) GPS AT Commands Serial Commands used by our Satellite transciever. python to send a SMS message
Read More

GPS AT Commands

Posted by - October 18, 2015

AT+CGPSPWR? if off : AT+CGPSPWR=1 Get status : AT+CGPSSTATUS? Get GPS : AT+CGPSINF RESET CODES : What mode ? – AT+CGPSRST? COLD Reset  – AT+CGPSRST=0 WARM Reset – AT+CGPSRST=1 ...
Read More

Keep Reading : GPS RESPONSE CODE ORDER Serial Communication with SMS Modem (FONA) Serial Commands used by our Satellite transciever. google map link
Read More

Send MMS From Serial Port on Raspberry Pi

Posted by - October 16, 2015

IF ANY COMMAND BELOW DOES NOT WORK CORRECTLY ADD A  Semicolon ‘ ; ‘   In order to establish the PPP connection: AT+CGDCONT? This should respond with the context you are on. This means you are ready to attach/connect. AT+CGATT=1...
Read More

Keep Reading : Updated GPS & Battery commands for Sim808 / FONA Shield. Also works for LoNet Sim808 Serial Communication with SMS Modem (FONA) GPS RESPONSE CODE ORDER SMS on PI
Read More

Raspi-config

Posted by - August 15, 2015

First you will need to open terminal. Terminal is located at the top of your raspberry pi screen. Terminal is used for running commands such as opening programs, editing  files, and you can also install applications and libraries as well as update...
Read More

Keep Reading : Serial Commands used by our Satellite transciever. GPS RESPONSE CODE ORDER Chain connect pressure/temperature module i2c on clock module Remote ssh connect from iPad P.C. and laptop using dynamic ip address
Read More